Intro to Slicing - Cura

Everything you need to go from .STL to printed file!

Course•By Denisa Dica

Introduction to 3D Printing

Everything you need to know to start 3D printing in the classroom!

Course•By InkSmith

k8 1.0 Lesson 1: Hello World!

Get started learning about programming your k8 robot with micro:bit and MakeCode.

Course•By Doug Braden

k8 1.0 Lesson 2: Motor control

Make the k8 move and learn how to control the motors that move the robot.

Course•By Doug Braden

k8 1.0 Lesson 3: Line Following

Use your robot's Infrared Sensors to line follow a 2D course.

Course•By Doug Braden

k8 1.0 Lesson 4: Ultrasonic

Use your robot's Ultrasonic Sensors to navigate around and avoid obstacles.

Course•By InkSmith

k8 1.0 Lesson 5: Radio Control

Learn how to turn an extra micro:bit into a remote controller for your k8 robot!

Course•By Doug Braden

k8 1.0 Lesson 6: Servo Control

Use your robot's servo motors to create grabbers and lifters.

Course•By Doug Braden

k8 Assembly: Building Your Robot (for k8 version 1.0)

This introductory course will help you get your k8 robot assembled and ready for programming.

Course•By InkSmith

k8 Lesson 7 - Robot Sports

Course•By InkSmith

k8 Lesson 8 - Sumo

Course•By Jeremy

k8 Robotics Courses Bundle

Get started building and programming your k8 Robot with these step-by-step interactive courses.

Course bundle•By InkSmith

Setting Up Your Cubicon Single Plus 3D Printer

Everything you need to know to get your Cubicon Single Plus set up and printing!

Course•By InkSmith

TinkerCAD and Model Sizing for Efficient Classroom Printing

Learn the basics behind setting print size limits to make sure that printing your models is simple

Course•By Jeremy